| Item
# |
Description
|
 |
| HM-1 |
White, Pigmented standard hot
melt for most surfaces. Fast set can be trimmed immediately. |
|
| HM-2 |
White, Pigmented hot melt for
hard to stick surfaces, such as clay coated and end grain. Not as
fast as HM-1, must have elapsed time before trimming. |
|
| HM-3 |
Clear, no pigment,
colorless glue line. Used on most surfaces. Fast set can be trimmed
immediately. Used as second coat in "two shot system with HM-4". |
|
| HM-4 |
Clear, no pigment, colorless
glue line. A very versatile product. Adheres to a wide variety of
difficult surfaces. Not as fast as HM-3, must have elapsed time
before trimming. Very flexible at low temperature and room temperature.
No "mouse trapping". Use as "Burst-Binding Hot Melt".
Use as prime coat in "two shot system". This unique hot
melt allows the binder to "pull a round" in books. |
|
| HM-5 |
Clear, no pigment, colorless
glue line. Used on clay coated, varnished and end grain surfaces.
Fast setting can be trimmed in line. Adhesion to a wide variety
of substrates. |
|
| HM-6 |
Opaque hot melt chips designed
for table top perfect binders that require lower viscosity. Can
be used on a two shot system as first coat. |
|
| HM-7 |
Clear, no pigment, tan glue
line. Designed for side gluing. Has the open time and adhesion range
to attach a wide variety of cover stocks. Non-pressure sensitive. |
|
| HM-8 |
An ethylene vinyl acetate offset
to PUR hot melts. Produces lay flat books, but requires longer setting
time. Offers economic advantage over PUR. |
|
| HM-9 |
A fast set, general purpose
hot melt for volume binding. Runs clean with three knife trimmer. |
|
| HM-10 |
A "Glue Stick" designed for
book repair. Has a very wide range of adhesion and a modest open
time for assembly work. |
|
| HM-11 |
A hot melt that is designed
to lower energy requirements. This is a general purpose product
that has a running temperature of 280°F and a set time of 4
- 6 seconds. HM-11 also adheres to wide variety of surfaces. |
